84xxWindowsSDK 关于控制Filter |
尚未結案
|
cphotel
一般會員 發表:4 回覆:1 積分:1 註冊:2003-10-05 發送簡訊給我 |
各位高手,我有一段84xxWindowsSDK,用来控制Realmagic解压卡声道,但我Delphi才刚刚入门,不知道怎么调用它来控制声道,忘各位Delphi高手帮个忙,我用的是Delphi6 DSPack2.3 REALmagic DirectShow Decoder Filter IMPEGTimeInfo interface("sdinterf.h") Sets and gets audio output directed to the digital to analog audio converter
(“sdinterf.h”) (DAC), to S/PDIF AC3 or S/PDIF PCM; specifies the left channel, right
channel or stereo as source (for Karaoke applications) GUID
// {AEB23DA0-54BB-11d2-BD98-0080ADB67301}
DEFINE_GUID(IID_IAudioOutput,
0xaeb23da0, 0x54bb, 0x11d2, 0xbd, 0x98, 0x0, 0x80, 0xad, 0xb6, 0x73, 0x1);; Supported API
interface IAudioOutput : public IUnknown
{
public:
STDMETHOD(GetOutput)(PAUDIO_OUTPUT pAudioOutput) PURE;
STDMETHOD(SetOutput)(AUDIO_OUTPUT AudioOutput) PURE;
STDMETHOD(GetMode)(PAUDIO_MODE pAudioMode) PURE;
STDMETHOD(SetMode)(AUDIO_MODE AudioMode) PURE;
}; GetOuput
SetOutput Outputs audio on the RCA connector or S/PDIF connector using PCM (with
RCA connector only) or AC3/DTS compressed format (Dolby Digital).
DIGITAL_AUDIO (=0) – Sound decoded and played through the On-board DAC.
PCM_AUDIO (=1) – Sound decoded and played through Quasar S/PDIF output (Orange RCA connector). This mode does not exist on NetStream 2000/Ventura 2000/Symphony/Xcard, or any product using the 8400 or more recent chip because S/PDIF and DAC are simultaneously enabled.
AC3_AUDIO (=2) – Sound is not decoded (However, for MPEG2 audio sources, sound is output as stereo PCM) and sent through Quasar S/PDIF output (Orange RCA connector). GetMode
SetMode Outputs the left or right channel (when content is stereo or joint stereo) to
both speakers, or resets to stereo (i.e. left channel on left speaker and right
channel on right speaker).
STEREO (=0) – Source is stereo.
LEFT_ONLY (=1) – Left channel on both speakers.
RIGHT_ONLY (=2) – Right channel on both speakers.
|
本站聲明 |
1. 本論壇為無營利行為之開放平台,所有文章都是由網友自行張貼,如牽涉到法律糾紛一切與本站無關。 2. 假如網友發表之內容涉及侵權,而損及您的利益,請立即通知版主刪除。 3. 請勿批評中華民國元首及政府或批評各政黨,是藍是綠本站無權干涉,但這裡不是政治性論壇! |